:  Jul 13, 2004











































.
  : Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.

. Remove the transfer case.

. Remove the Allen bolt retaining the adaptor shaft.
  Use the special tool to hold the adaptor shaft.




. Remove the adaptor shaft.
  Use the special tools.




. Remove the output shaft seal.
  Use the special tool.




.
  : Oil seals must be fitted dry.

Install a new output shaft seal.
  Clean the component mating faces.
  Use the special tool.




.
  : Wear protective gloves.

Install the adaptor shaft.
  Clean the component mating faces.
  Heat the adaptor shaft evenly to 120 degrees Centigrade before fitting the adaptor shaft to the splines.

. Install the Allen bolt.
  Use the special tool to hold the adaptor shaft.
  Apply sealant to the Allen bolt thread.
  Tighten the Allen bolt to 68 Nm (50 lb.ft).




. Install the transfer case.

. Drain and refill the transmission.