:	Apr 30, 2004

:

The receiver drier need only be changed under the following circumstances: There is dirt in the refrigerant circuit ( eg. compressor seizure ). The system is leaking and refrigerant has been lost to atmosphere. Refrigerant circuit has been open more than 24 hours due to repair.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the A/C condenser.

.

Remove the receiver drier support bracket clamp.   Loosen the screw.

.

: Immediately cap all refrigerant lines to prevent ingress of dirt and moisture. Remove the receiver drier.   Remove the bolt.   Remove the clamp.   Remove and discard the 2 O-ring seals.

.

Install the receiver drier.   Clean the component mating faces.   Install new O-ring seals.   Install the clamp.   Tighten the bolt to 10 Nm (7 lb.ft).

.

Install the receiver drier support bracket clamp.   Tighten the screw.

.

Install the A/C condenser.