: | May 7, 2008 |
![]() |
If the parking brake system has completed less than 50,000 cycles it is permissible to replace the parking brake cables. If over 50,000 cycles have been completed, then the cables can only replaced as part of the parking brake actuator and cable assembly. The parking brake cycle count can be checked using T4, (ON/OFF = 1 cycle). If a cable breaks or becomes detached whilst the vehicle is being driven, a 'parking brake actuator unblocking procedure' may be required via T4. |
. | Using the Land Rover approved diagnostic system, drive the parking brake to the 'mounting position'. |
. | Isolate the parking brake electrical circuit.
|
. |
Raise and support the vehicle. |
. | Remove the wheels and tires. |
. | Release the parking brake shoe adjustment.
![]() |
. |
Reposition the RH rear brake caliper.
![]() |
. | Remove the RH rear brake disc.
![]() |
. | Disconnect parking brake cable from the wheel
hub.
![]() |
. |
Release the fuel tank breather line bracket.
![]() |
. | Release the RH parking brake cable.
![]() |
. | Release the RH parking brake cable. ![]() |
. |
Remove the RH parking brake cable.
![]() |
. | Install the RH parking brake cable.
|
. | Secure the fuel tank breather line bracket.
|
. | Locate and secure the RH parking brake cable.
|
. |
:
Connect the parking brake cable to the wheel hub.
![]() |
. |
Install the RH rear brake disc.
|
. | Secure the RH rear brake caliper.
|
. |
:
Adjust the parking brake shoes. |
. | Install the rear wheels and tires.
|
. | Install fuse number 8 into the BJB. |