:	Jun 21, 2004

.

Disconnect the battery ground cable.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the front wheels and tires.

.

Remove the cylinder block cradle.

.

Remove the oil pump assembly.   Remove the 2 Torx screws.   Remove the driveshaft.

.

:   Do not disassemble further if the component is removed for access only. Remove the oil pickup pipe.   Remove the 3 Torx screws.   Remove and discard the seal.

.

Install the oil pickup pipe.   Clean the component mating faces.   Install a new seal.   Tighten the Torx screws to 10 Nm (7 lb.ft).

.

: The oil pump driveshaft is not symmetrical. The longer end shown, is fitted into the oil pump. Install the oil pump assembly.   Clean the component mating faces.   Prime the oil pump.   Install the driveshaft.   Tighten Torx screws to 20 Nm (15 lb.ft).

.

Install the cylinder block cradle.

.

Install the front wheels and tires.

.

Connect the battery ground cable.