:	Aug 2, 2006

:

New air suspension components are supplied with new Voss connectors tightened to the correct torque. Therefore, do not install new Voss connectors if a new component is being installed.

.

Using T4, depressurize the air suspension.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the air suspension compressor lower cover.   Remove the 3 bolts.   Release the 5 clips.

.

: Always plug any open connections to prevent contamination. :   Access to the top compressor fixing bolt is very restricted. It is advisable to use a 1/4 inch drive socket with a flexible coupling. Remove the air suspension compressor.   Disconnect the 3 air lines.   Disconnect the 2 electrical connectors.   Remove the 3 bolts.

.

: Make sure that the wiring harness and the air suspension pipes are not trapped behind the air suspension compressor bracket.   : Make sure the air suspension compressor upper cover is correctly positioned. :   Install the upper retaining bolt, but do not fully tighten, before installing the 2 lower retaining bolts. Install the air suspension compressor.   Tighten the bolts to 10 Nm (7 lb.ft).   Connect the air lines.   Connect the electrical connectors.

.

Install the air suspension compressor lower cover.   Install the bolts and tighten to 9 Nm (7 lb.ft).

.

Using T4, pressurize the air suspension.