:	Jul 15, 2005

.

Remove the rear door window motor and regulator assembly.

.

: Release the exterior door handle and screw cover clips from inside the door. Remove the rear door exterior handle.

.

Release the remote control cable.   Release the grommet.

.

Release the door exterior handle mechanism.   Remove the 2 Torx screws.   Remove the locking pin.

.

Remove the rear door latch assembly.   Disconnect the electrical connector.   Remove the 3 Torx screws.

.

:   Do not disassemble further if the component is removed for access only. Remove the door latch remote control cable.   Release the cable from the abutment bracket.   Remove the cable from the lever.

.

Release the exterior door handle mechanism cable from the door latch.   Release the cable from the abutment bracket.   Remove the cable from the lever.

.

Connect the door exterior handle mechanism cable to the door latch.   Connect the cable to the lever.   Secure the cable to the abutment bracket.

.

Install the remote control cable to the door latch.   Connect the cable to the lever.   Secure the cable to the abutment bracket.

.

Set the exterior handle mechanism.   Rotate the lever.   Engage the retaining tang.

.

Install the rear door latch assembly.   Tighten the Torx screws to 10 Nm (7 lb.ft).   Connect the electrical connector.

.

Install the door exterior handle mechanism.   Position the mechanism to the door.   Fit the locking pin.   Install and tighten the Torx screws.

.

Position the remote control cable to the door.   Install the grommet.

.

Install the rear door exterior handle.

.

Install the rear door window motor and regulator assembly.